Turn the craft around and do the same.Lower the upper part.
Bend the upper corner one third of the distance to the horizontal line and unbend again.
If you look at the figure above, you will see a small square received from the fold.Fix the sides with your fingers to bend. The two sides bend inward this square, and the front and back - connect.
Fold the figure as it was before.Take the lower corner of the craft and open it upwards. The lower part will be forked. To the right, draw a line from the center to the bottom side at a right angle. In the left bottom corner, divide into three parts and draw a line from the side corner through the bottom marking to the middle line.Bend both details on these lines.Turn the right curved corner and bend it along the intended bends inwards. He will be "looking" up. Turn the left curved corner too.Summarize it. Next to the fold, draw a line as shown in the photo. On the top "wing" draw a vertical line.Bend the bottom corner downwards and the top corner to the left.Turn the corner along the intended folds.Smooth. Bend it again as in the photo.The bottom of this small triangle should be horizontal. This is a paw. Here is such a figure you have now.Now lower its upper part down, as if closing it.The figure is already a little bit like a bird.Pay attention to the angle where the pointer is.It should be a little bit beyond the top part. This is the breast of the neck. Make it your head. Bend, looking up, the triangle to the right.Turn it out.Fold the tip with it, making a beak. Remove it too.There are markup in the upper part of the shape.Bend both sides along them to the middle.Turn right side to the left and the bent details will be inside.Bend wings so thatso that they were on the same level with legs.Your neck is ready.
Fold the figure as it was before.